AOR SDU5600 Specifications download pdf (Page 41)

Spectrum analysis

Command : WSCF Function : SET CENTER FREQUENCY Command category: WRITE

Parameter : Min- Max (in MHz)

Example : WSCF79.5<CR><LF> Response: if correct: <SP><CR><LF>

if incorrect: ?<CR><LF>

Remarks: Frequency entry for out of receive range will be respond by ?<CR><LF>, and the

command will be ignored.

Command : RSCF Function : READ CENTER FREQUENCY Command category: READ

Parameter : N/A

Example : RSC<CR><LF> Response: SCF79.5<SP><CR><LF>

Remarks: Frequency is displayed in MHz.

Command : WSSP Function : SET SPAN FREQUENCY Command category: WRITE

Parameter : 0.16 ~ 10 (MHz)

Example : WSSP0.62<CR><LF> Response: if correct: <SP><CR><LF>

if incorrect: ?<CR><LF>

Remarks: Data entry for out of range will be respond by ?<CR><LF>, and the command will be

ignored.

Command : RSSP Function : READ SPAN FREQUENCY Command category: READ

Parameter : N/A

Example : RSSP<CR><LF> Response: SSP0.62<SP><CR><LF>

Remarks: Frequency is displayed in MHz.

Command : WSBW Function : SET RBW Command category: WRITE

Parameter : 1 ~ 4

Example : WSBW1<CR><LF> Response: if correct: <SP><CR><LF>

if incorrect: ?<CR><LF>

Remarks: Parameter vs. RBW is as follows: 1 = 4 KHz, 2 = 32 KHz, 3 = 64 KHz, 4 = 128 KHz

Data entry for out of range will be respond by ?<CR><LF>, and the command will be ignored.

Command : RSBW Function : READ RBW Command category: READ

Parameter : N/A

Example : RSBW<CR><LF> Response: SBW4<SP><CR><LF>

Remarks: Parameter vs. RBW is as follows: 1 = 4 KHz, 2 = 32 KHz, 3 = 64 KHz, 4 = 128 KHz.

Command : WSGN Function : SET AMPLITUDE Command category: WRITE

Parameter : -30 ~ 0

Example : WSGN-30<CR><LF> Response: if correct: <SP><CR><LF>

if incorrect: ?<CR><LF>

Remarks: Amplitude is set in 10 incremental. Data entry for out of range will be respond by

?<CR><LF>, and the command will be ignored.

Command : WSCM Function : SET CURSOR Command category: WRITE

Parameter : 1 ~ 3

Example : WSCM3<CR><LF> Response: if correct: <SP><CR><LF>

if incorrect: ?<CR><LF>

Remarks: Parameter : 1 = MARKER, 2 = PEAK, 3 = C-PEAK To use this command, you need to set

the trigger level by using the WSTL command. Data entry for out of range will be respond by

?<CR><LF>, and the command will be ignored.

Command : RSCM Function : READ CURSOR Command category: READ

Parameter : N/A

Example : RSCM<CR><LF> Response: SCM1<SP><CR><LF>

Remarks: Parameter : 1 = MARKER, 2 = PEAK, 3 = C-PEAK

Section 8-4

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 51 52

Comments to this Manuals

No comments

AOR SDU5600 Specifications Page 41

Comments to this Manuals

Related products and manuals for TVs & monitors AOR SDU5600