AOR AR8200 Specifications download pdf (Page 37)

The third line will display “OFFSET 00” with “00”

indicating that frequency offset is currently off,

there will be no “DUP” legend displayed when the

frequency offset is OFF. The bottom line of LCD

will display “- - - . - - - -“ indicating that no offset

is stored. Use the main dial or ï ð keys to

review the offset locations, particularly numbers

20 to 47 where useful factory

programmed offsets may be stored.

As soon as you shift from location

00, the “DUP” duplex legend is

displayed on the LCD to indicate that frequency offset is in use.

Presuming that data is already programmed into an offset location,

the key to toggle offset between “+” positive and

“-“ negative offset, this is a

global toggle

and affects ALL

frequency offset channels (but not those already stored into

memory or search banks). To accept the offset setting,

. The LCD will revert to its operation prior to the frequency

offset menu being called. The LCD legend “DUP” will be displayed

to indicate that frequency offset has been activated.

To use the frequency offset , the LCD frequency

will alter to take account of the offset ‘value & direction’ and the

squelch will be defeated. When you release the key, the

AR8200 will revert to the original frequency (and squelch will close

if no signal is present).

&Note: Each VFO, memory channel and search bank can be programmed with a different

frequency offset. If different channels and offsets have been programmed to VFOs etc, the

key sequence will recall the specific offset location originally

used during programming, this is particularly useful when you simply wish to toggle the + / -

offset.

To cancel the frequency offset, access the frequency offset menu and select location “00”, the “DUP”

legend will be removed from the LCD.

3-10-2 Entering new frequency offset data

Assume that you are in VFO mode with a frequency of 433.000 MHz

To access the frequency offset set-up menu

The third line will display “OFFSET 00” with “00” if the frequency offset is currently off, there will be no

“DUP” legend displayed when the frequency offset is OFF.

Use the main dial or ï ð keys to select an unused frequency offset location between the numbers of 01

and 19 inclusive (00 being interpreted as off and 20 - 47 reserved for pre-programmed data).

Section 3-10-1, 3-10-2

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 141 142

No comments

AOR AR8200 Specifications Page 37