AOR AR5001D User's Guide download pdf (Page 75)

Using SignalTrack

ENCRYPTION

The messages sent between SignalTrack and any direction finding site with a computer can be

encrypted if desired. Encryption is enabled and disabled by use of the Encryption tab in the

Options menu. The default condition is encryption off.

To enable encryption select Options from the Setup menu and click on the Encryption tab. The

following dialog will be displayed

Enabling or disabling encryption requires a password. To obtain this password you will need to

contact the factory (davec@dopsys.com). When you've obtained the password type it in and press

the Enter key. Once you've entered the password, the controls on the dialog will be active. Press

Change to change the password. Select the Encryption Method you want to use to enable

encryption. Once encryption is enabled, you must enter an encryption key. This key must be 16

characters long for AES encryption and 7 characters long for DES encryption. Any series of

characters is acceptable.

Note: When encryption is enabled all remote sites communicating with SignalTrack via a computer must use

the same key or the encryption will fail.

The dialog shown below is an example of the dialog with encryption enabled.

Figure 45: Enable Encryption by Entering the Password

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 119 120

No comments

AOR AR5001D User's Guide Page 75