AOR AR5001D User's Guide download pdf (Page 61)

Using SignalTrack

MOBILE OPTIONS

The general mobile options dialog is shown in the Figure below.

- COM port. Select the serial port you have connected the direction finder to.

- Receiver. If the ICOM Receiver box is checked AutoTrack tries to communicate with the

receiver using CIV. The CIV address of the receiver must match the value in RX Addr drop down

combo box. If you are using an AOR receiver with a RS-232 connection you can simply plug in the

AOR receiver into one of the serial ports on the DDF6002 or DDF6100. If you are using an ICOM

PCR 1500 receiver you must install the drivers for the receiver on the PC prior to using SignalTrack.

The PCR 1500 manual contains instructions for installing the drivers.

- Enable AutoScroll. When AutoScroll is enabled the map will automatically scroll as specified in

the AutoScroll options.

- AutoScroll Options. AutoScroll Options allows you to select how the current position and

estimated RF source location are displayed.

If Keep Current Location on Map is selected, Auto Track attempts to keep both the current

active site and the estimated position of the RF source on the map. If it cannot keep both of them

on the map it will keep the current location on it.

The Keep Estimated Source Location on Map behaves the same as Keep Current Location on

Map except that if both locations cannot be displayed on the map the Estimated position is displayed.

The Keep Current Location centered on the Map option forces the current location to be

centered on the map and as the vehicle moves, the map moves and the location stays centered.

The Keep Estimated Location centered on the Map option forces the estimated location to be

centered on the map.

- Center Bearing Display on Active Site. If this check box is checked the bearing display will

move with the active site as it moves on the map. See Displaying the Direction Finder Bearing.

- Disable Compass. This check box disables the compass if it is installed.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 119 120

No comments

AOR AR5001D User's Guide Page 61