AOR SDU5600 Specifications download pdf (Page 14)

2 Getting started

2-1 Making the AR-ONE ready for operation

2-1-1 LCD (Liquid Crystal Display)

All relevant operational information is provided via the LCD. The LCD contrast is adjustable.

2-1-2 Connect the antenna

For reception on all bands, connect the antenna to the N connector on the rear panel of

the AR-ONE. Refer to chapter 10 for an overview of the available AOR antennas depending

on your target frequency range.

2-1-3 Connect power

Connect power to the DC power jack on the rear panel of the AR-ONE. For optimal

performance use a regulated DC power supply (12 ~ 14 V with capacity 2A).

Do not connect to a 24 V system.

(DC power socket design may vary depending on AR-ONE generation)

2-2 Switching on for the first time

Set the squelch control to the ‘mid point’. Turn the power switch on the rear panel of the

AR-ONE. This is a main power switch. The green LED on the switch will illuminate. Then

rotate the PWR/VOL control to the ‘mid point’, as you start to rotate the PWR/VOL control, a

‘click’ will be heard as the power isolation switch contact switches on. Please be careful NOT

to switch on any receiver with an earphone connected, there may be an audible click when

the unit is switched on or the volume may be accidentally set too high.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 73 74

No comments

AOR SDU5600 Specifications Page 14