AOR AR2700 User Manual download pdf (Page 9)

- 9 -

The command ML[ï] may be used to check the current status of scan bank link.

To change the status of scan bank link, the MLn[ï] command is used

where n = 0 Bank link OFF

n = 1 Bank link ON

Related commands MG MS

BQ is the equivalent command for SEARCH.

The MP command is used to register the current memory channel as PASS

(so that it will be skipped during scan). The command is generally used in

conjunction with the “MR” command.

To check the current status of PASS use the command MP[ï]

The response will be MP0 Memory PASS OFF

MP1 Memory PASS ON

It is possible to change the status of memory channel PASS using the command:

MPn[ï] where n = 0 Channel PASS OFF

n = 1 Channel PASS ON

Related commands BN MQ MR MG MS

Delete the current memory channel OR bank.

The MQ command can only be used in M.RE (memory read) mode. It is used to delete memory channels

or a whole memory bank in one go. The memory bank must first be recalled as the active bank.

Note: Once memory channels have been deleted the data is lost. They can not be reinstated but new data

has to be written to the channel if required.

The command MQ[ï] deleted the current memory channel.

The command MQnn[ï] deletes the specified memory channel from the current bank were

nn = 00 ~ 49

The command MQ%%[ï] deletes ALL memory channels from the current memory bank.

Related commands BN MP MR MG MS

Place the receiver in M.RE - memory read mode.

The MR command is used to place the receiver into memory read mode. The MR command is also required

before channels may be deleted using the MQ command.

The MR[ï] command places the receiver in memory recall mode and the last used channel data is reported.

It is possible to specify both the memory bank and channel number for recall:

MRxnn[ï] where x = memory bank 0 ~ 9

nn = channel number 00 ~ 49

A typical response to the MR command may be:

MX043_MP0_RF0435120000_AU1_MD1_ST020000_AT0

Memory location: 043

Receive frequency: 435.12 MHz

Step size: 20 kHz

Receive mode: NFM

Attenuator: OFF

MP MQ MR

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

AOR AR2700 User Manual Page 9