AOR AR2700 User Manual download pdf (Page 16)

- 16 -

Note: Entry and response are in different formats, the entry does not use the decimal point.

Related commands MG MS SG SS

Priority interval time.

The TI command is used to set the priority interval time (how long to wait between checking the priority

channel for activity).

To check the current setting use the format TI[ï]

The response will be TInn where nn = 01 ~ 19 seconds.

A typical response may look like TI13

To change the timing use the format TInn[ï] where nn = 01 ~ 19 seconds.

This command is used to register the pause time in 1 second intervals between the range of

1 to 99 seconds..

To check the current setting use the format TP[ï]

The response will be TPnn where nn = 01 ~ 99 seconds.

A typical response may look like TP13 (13 = 13 seconds).

To change the timing use the format TInn[ï] where nn = 01 ~ 99 seconds.

Related commands MG MS PU SG SS

é ê

UP / DOWN arrows.

The é ê arrow commands have largely the same effect as the arrow keys on the front panel of the

AR8000 receiver. In VFO mode the frequency is incremented upward or downward, in memory recall mode

the next channel is selected and in search/scan modes the direction of search/scan may be reversed.

The value for é is "h1E" (HEX DECIMAL) and the command may be sent using the format é[ï]

The value for ê is "h1F" (HEX DECIMAL) and the command may be sent using the format ê[ï]

Related commands MG MS SG SS

TI TP

é ê

AOR, LTD

2-4-6 Misuji, Taito-ku, Tokyo 111, Japan

TEL (03) 3865 1681

1 2 ... 11 12 13 14 15 16

No comments

AOR AR2700 User Manual Page 16