AOR AR2700 User Manual

- 1 -The New ConceptCU8232Remote Control InterfaceSupplementfor the AR2700Hand Portable Radio ReceiverTM

- 10 -A response of: MX700_— indicates that memory 7 bank has no data programmed or it has has beendeleted.Related command BN MA MP MQ é êMSStart me

- 11 -PDDelete PASS frequencies in search mode.There are a total of 50 PASS frequencies, they may be deleted on an individual basis or the whole bank

- 12 -The command PW[ï] being used.Related commands PD PR PS SG SSQPUsed to turn the receiver power switch Off (cannot be used to switch the receive

- 13 -SCSet operating code for option (not available in the UK).The SC command is used to review and select the operating code if the option is fitted

- 14 -The command SGx[ï] causes an automatic response and searching from the specified bankwhere x = 0 ~ 9.Related commands LC MG SS é êSISet co

- 15 -SSEngage search mode - start search.The SS command is used to start the search process from either the current or specified search bank.To start

- 16 -Note: Entry and response are in different formats, the entry does not use the decimal point.Related commands MG MS SG SSTIPriority interval

- 2 -Thank you for purchasing the CU8232 computer control interface for operation with the AR2700 receiver.Every effort has been made to make this sup

- 3 -The [PROGRAM] socket is the primary receiver connection used for computer control. This port also takespower from the receiver (when the AR2700

- 4 -Connection & commands(4) Connection for RS232 operationThe connection and setup parameters are identical to those for the AR8000 receiver...

- 5 -SU Register the end freq of search mode.TI Register the interval time of Priority channel.TD Register the delay timeTP Register the pause timeArr

- 6 -Type BM followed by the bank letters and terminated with [ï]BM 1348 [ï]The BM command may be used to switch some banks On and others Off at the s

- 7 -EXEnd remote operation and restore keypad operation to AR2700.To end RS232 remote operation type EX[ï]This has the same effect as pressing the [C

- 8 -The first memory channel data being:Memory location: 100Memory pass: OFFReceive frequency: 594 kHz (0.594 MHz)Step increment: 9 kHzAuto mode: ONR

- 9 -The command ML[ï] may be used to check the current status of scan bank link.To change the status of scan bank link, the MLn[ï] command is usedwh