AOR AR-ONE Specifications Page 32

  • Download
  • Add to my manuals
  • Print
  • Page
    / 86
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 31
http://entropy.brneurosci.org/radio-misc.html
32 / 86 28.8.2007 13:16
Demodulation modes .......... CW, SSB, ISB, AM, FM, I/Q
Carrier operated relay ...... Standard
AM sensitivity .............. 30% amplitude modulation at 400 Hz with
bandwidth of 6.4 kHz for 10 dB (s+n)/n
0.1 to 30 MHz ............. 3 uV
>30 MHz.................... 2 uV
FM sensitivity .............. SINAD of 12 dB with bandwidth of 12.8 kHz
2 to 30 MHz ............... 1.1 uV
>30 MHz.................... 0.5 uV
SSB/ISB/CW sensitivity ...... SINAD of 10 dB with bandwidth of 3.2 (1.6
CW) kHz and the input signal tuned 400 Hz
from the dial frequency
0.005 MHz.................. 13uV (typical)
>0.1 MHz................... 0.4 uV
Second order input intercept
<30 MHz ................... +80 dBm (typical)
>30 MHz.................... +60 dBm (typical)
Third order input intercept
<30 MHz.................... +25 dBm (typical)
30 to 500 MHz ............. +7 dBm (typical)
>500 MHz .................. 0 dBm (typical)
Image rejection ............. >100 dB
IF rejection
<30 MHz ................... >80 dB
>30 MHz ................... >100 dB
Internal spurious ........... Less than equivalent antenna input
of -115 dBm
Conducted LO at antenna ..... <-110 dBm
Manual gain control ......... 1 dB increments
<30 MHz ................... 144 dB range
>30 MHz ................... 126 dB range
AGC range ................... +/-1.5 dB at audio output, with input
signal level range from 10 dB above
noise floor to 0 dBm
AGC programmability ......... AGC attack, hang, and decay time and
threshold values
Standard IF bandwidths ...... 74 programmable between 100Hz and 300kHz
Maximum input level
Operating
<30 MHz ................. +10 dBm
>30 MHz ................. 0 dBm
Nonoperating
<30 MHz ................. +43 dBm
>30 MHz ................. +33 dBm
Signal strength accuracy .... +/-2 dB over 0.1 to 2000 MHz frequency range
Postdetection audio filter .. Software selectable low-pass filters:
4.0 kHz, 25 kHz, 50 kHz, or bypass
Primary antenna input ....... 50 ohms impedance, VSWR <3:1; usable over
input frequency range of 2 to 2000 MHz, with
degraded performance below 30 MHz, compared
to HF antenna input
HF antenna input ............ 50 ohms impedance, VSWR <3:1; usable over
input frequency range of 0.005 to 30 MHz
HF antenna output ........... 50 ohms impedance, internally connected to
the primary antenna input when tune frequency
is below 30 MHz
Phone A&B out ............... 0.5 volt RMS into 100 ohms (max), 1% THD
Line A&B out ................ 0 dBm, 600 ohms (nominal)
Speaker A or B or A+B out ... 1 watt (max), 8 ohms, <10% THD
Input power ................. 9 to 16 V dc, 22 watts 85 to 240 V ac,
47 to 440 Hz
Mechanical
Packaging ................... EIA 1U rackmount, 1.72 in (43.6 mm)
H x 19 in (483 mm) W x 14.75 in (375 mm) D
RF connectors ............... BNC
Audio connector ............. DB1 5F
RS-232 connector ............ DB9F
Weight ...................... Approx 9.0 Lb (4.8 kg)
Operating temperature ....... 0 to 50 øC
Storage temperature ......... -55 to +70 øC
Humidity .................... 95% noncondensing
Shock ....................... Bench handling
Altitude .................... <10,000 ft
Cooling ..................... Convection
Page view 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 85 86

Comments to this Manuals

No comments