AOR AR5000 User Manual download pdf (Page 65)

AR5000 OPERATING MANUAL PAGE 65

SLEEP Programming

To set how long the AR5000 will remain active before

automatic switch off (you may abort entry by pressing the

key):

1 Press the key then press and hold the

key

for more than one second.

2 “SLEEP” legends flash on the LCD prompting for input

of sleep time. The MAIN DIAL or SUB DIAL may be rotated

to make selection between 1 and 120 minutes, the default

being 30 minutes.

3 Press

key to complete data entry and return to

the normal frequency / text display.

4 The “SLEEP” legend will be displayed in the centre top

of the LCD to indicate that SLEEP has been set. The

sleep facility is always activated when exiting the sleep

programming menu using the

key. If you do not

wish the sleep timer to activate now press

If left active, the AR5000 will automatically switch off after

the sleep time duration has expired.

SLEEP activation On/Off

To toggle the SLEEP facility On/Off press

The “SLEEP” legend will be displayed on the top line of

the LCD when sleep facility is active. Note that the

key must only be momentarily pressed or the sleep setup

menu will be activated.

When the sleep time has elapsed the AR5000 will

automatically switch off.

(15) Option - Descrambler (voice inverter)

- DS8000

An optional voice inversion unit may be fitted to the

AR5000 to enable decoding of certain types of analogue

scrambling (such as some cordless phones). Such a board

is not produced by AOR but the receiver has been

designed to accept the DS8000 - available from dealers

in some countries.

15-1 Descrambler installation

Only the upper case of the AR5000 needs to be removed

when installing the optional DS8000 board. Switch the

receiver off and unplug the power cord.

1 In order to lift the upper case,

carefully

(with the correct

fitting posi-drive screwdriver) remove the 4 screws from

the top cabinet and the 3 screws from each side panel

(the screws on the side of the unit toward the front are

larger than the rest). The rear edge of the top cabinet

has a flange and the sides have two unused holes (for

mobile mounting).

2 Locate connector J10 in the middle of the IF printed

circuit board (see illustration) and insert the DS8000

making sure the pins mate correctly.

3 Refit the upper case... you may wish to do this once

you have established that the board is operating correctly!

4 The DS8000 must be REGISTERED in the receiver’s

configuration before it will appear on the OPTION MENU

and be used. Plug in the power cord and ensure that the

supply is connected and active.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 76 77

Comments to this Manuals

No comments

AOR AR5000 User Manual Page 65

Comments to this Manuals

Related products and manuals for Receiver AOR AR5000