AOR AR-ONE Specifications download pdf (Page 8)

1-2 Take care of your radio

There are no internal operator adjustments. In the unlikely event of servicing being

required, please contact your dealer for technical assistance.

Do not use or leave the receiver in direct sunlight (especially the LCD). It is best to avoid

locations where excessive heat, humidity, dust and vibration are expected. Always

keep

the AR-ONE free from dust and moisture. Use a soft, dry cloth to gently wipe the set

clean, never use abrasive cleaners or organic solvents which may damage certain

parts.

Treat the AR-ONE with care, avoid spillage or leakage of liquids into the receiver and

associated power supply. Special care should be taken to avoid liquid entering around

the controls, through the speaker grille or via the connection jacks.

The AR-ONE is designed for operation from a good quality regulated DC supply of 12

14 V, which should be capable of supplying 1.5 amps. Never connect the AR-ONE

directly to the AC outlet.

The DC input jack is configured Center Positive, the chassis of the receiver is at

negative ground. Where provided (depending upon world market location), the power

supply is pre-wired and provides a nominal 12 V DC output with suitable connectors

being fitted as standard for the AC power input and connection to the AR-ONE.

SAFETY NOTICE – Always disconnect the power supply from the AC outlet when

not in use. If used mobile, it should be noted that the AR-ONE has NOT been

manufactured or tested to meet any specific mobile safety requirements.

The AR-ONE has no internally user adjustable parts.

If using the AR-ONE in a base station situation, the best short wave reception is usually

achieved by the fitting of a separate external earth rod, however, consider the

implications carefully if your AC building supply uses a Protective Multiple Earth (PME)

system. If in doubt consult an expert electrician. Never earth to a gas pipe!

The AR-ONE has a single N type antenna connector for all frequencies. This is intended

for connection to a 50 ohm (unbalanced) coaxial fed antenna such as a discone, dipole,

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 83 84

No comments

AOR AR-ONE Specifications Page 8