AOR AR-ALPHA Specifications Page 1

® AR-IQ Receiver Control, I/Q Record & Playback for AR-ALPHA AOR Ltd. Authority On Radio Communications

8 3-4 Locate the folder containing the I/Q driver by clicking on “Browse”, to find the driver location. 3-5 If you are loading th

9 4 Software Installation ① Copy the folder “AR-IQ software v.X” (“X” being the version number) from the supplied CD to any location in your har

10 5 Software registration 5-1 Using the software on a single PC The software is free for unlimited use on a SINGLE PC, nevertheless you need to

11 license file in the supplied mailbox within a few days. If no Internet connection is available, the “SAVE REQUEST TO FILE” button should be used,

12 6 Software functions

13 Attenuators (1) Attenuators allow you to attenuate the input signal by a preferred amount. Users can choose among 0, 10 and 20

14 Frequency and tuning (6) This indicator always shows the current tuned frequency. If the operation mode is not set to “Center” (in the “IF FILTER”

15 S-Meter (12) The S-Meter shows the current signal level and also provides the means to set squelch and auto mute functions. Squelch level can

16 Averaging (16) Main and secondary spectrum display averaging can be enabled by clicking on the button over the respective sliders. Slider position

17 ® AOR Ltd. 2-6-4 Misuji, Taito-ku, 111-0055 Tokyo, Japan www.aorja.com [email protected] Author

1 Introduction AR-IQ software allows direct control of the AR-Alpha receiver through a graphical interface. The recorded samples are

2 Table of contents Introduction ..1 1 Minimum system requirements

3 1 Minimum system requirements ● 2.5 GHz Dual Core CPU with 1GB RAM ● Two available USB 2.0 High-Speed (480Mbit/s) ports. (Three ports if the

4 2 USB driver installation ◆ All following screenshots were made using Windows XP. Messages appearing on screen may differ slightly depending o

5 2-5 Locate the folder containing the USB driver by clicking on “Browse”, to find the driver location. 2-6 If you are loading the

6 2-8 Click “Finish”. The USB driver is now installed.

7 3 I/Q driver installation ◆ All following screenshots were made using Windows XP. Messages appearing on screen may differ slight