AOR AR5001D User's Guide download pdf (Page 54)

SignalTrack User's Guide

T to indicate tone dialing is to be used

, to force a pause (usually used after an access number)

* tone dialing only

# tone dialing

A-D special characters

( separates numbers

) separates numbers

- separates numbers

 For Ethernet connections, enter the IP address and the port to be used for the connection or

select the URL radio button and type in the URL of the site. If DigiOne devices are used to

connect the direction finder to the network, the default port is 2101.

 Ethernet connections can use UDP or TCP. In cases where network latency is sporadic UDP

usually provides more timely data. If UDP is used then the server (DigiOne) must be

programmed to act as a UDP server (see networking manual).

 If the fixed site has device such as a Barix Instreamer to stream audio to the site select the

Monitor Audio checkbox to enable audio monitoring of this site.

Continue setting up sites as described above until you have data entered for all the fixed sites in your

network and then click the Done button.

CHANNELS AND SCANNING

SignalTrack can save specific frequencies as channels and perform a rudimentary scan of the channels.

Additionally, SignalTrack can be used to set up and scan receiver memories for the ICOM R8500 and

the AOR AR5000 receivers. This section will explain how to save channels and how to set up

frequency scans.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 119 120

No comments

AOR AR5001D User's Guide Page 54